Printers  
Interface Cards

 

Connect-It Interface Card Installation

Make sure you have these items:

  • Connect-It module

  • Epson printer

  • small screwdriver
     

1) Removing the interface board from the printer
 

If there is a module installed in the printer you must first remove it. Remove the two screws that securing the interface board; then pull the board to remove it. You will reuse the screws when installing the new module

Tip: If storing the module put the removed interface board into an anti-static bag for storage to prevent damage from static electricity.

 

2) Installing the interface board enclosed in the package

Hold the Connect-It module as shown in the illustration below. Push the Connect-It module in gently until you feel the connector fit into place

3) Secure the Connect-It module with the two screws. Do not over tighten.

 

4)

 

4) Change the printer settings to match the new interface.

Dip switch settings for interfaces

Interface cards:


Home |  Printers |  Accessories |  Price List |  Service |  Contact
 

30-day guarantee on everything we sell

E-Mail: [email protected]

Call:
800-253-6407

Copyright© 2023 Beagle Hardware

Beagle Hardware is a BBB Accredited Business. Click for the BBB Business Review of this Computers Software & Services in Minneapolis MN